다울빛 이주여성 연합회

logo

한국어

정보마당

Bella2020.12.18 15:30
Click here to buy 3214 SKF Bearing

The state of NTN imported bearings is directly related to the operating status of rotating equipment. NTN imported bearings are widely used in equipment. Especially in large continuous production enterprises, it is widely used in important parts of large-scale rotating equipment. Therefore, the condition monitoring and fault diagnosis of NTN imported bearings in actual production is an important part of improving equipment maintenance and management. After temporary practice and exploration, we have accumulated some practical skills for actual fault diagnosis of NTN imported bearings.

1. Methods and key points of NTN imported bearing fault diagnosis
A practical method for condition monitoring and fault diagnosis of NTN imported bearings is vibration analysis.
It is necessary to pay attention to the accuracy and truth of the collected signal, and to choose the location of the measuring point and the collection method in practice. To truly and accurately reflect the vibration state of NTN imported bearings. Therefore, the measuring point should be arranged at the place closest to the bearing. Generally, the free end of the motor has a rear fan cover, and the measuring point is selected at the fixed screw of the fan cover for better monitoring effect. In addition, it is necessary to pay attention to collecting and analyzing the vibration signal many times, and then comprehensively compare it to get an accurate conclusion.

2. Features of normal operation of NTN imported bearings and practical diagnostic skills
NTN imported bearings showed strong regularity during their use, which was discovered during temporary production status monitoring. And the repeatability is very good. The vibration and noise of normal high-quality bearings are relatively small at the beginning of use, but the frequency spectrum is somewhat scattered and the amplitude is small, which may be caused by some defects in the manufacturing process, such as surface burrs.
The vibration and noise are maintained at a certain level after a period of exercise. The frequency spectrum is very single, with only one or two octave frequencies. There is rarely a frequency spectrum above three times the power frequency, and the bearing state is very stable, entering a stable working period.
Bearing vibration and noise began to increase and entered the later stage of use after continued operation. Sometimes there are abnormal noises, but the increase in vibration changes slowly. At this time, the kurtosis value of the bearing suddenly reaches a certain value, and the bearing is considered to be an initial failure at this time.
The bearing is required to be closely monitored at this time. Pay close attention to its changes. Afterwards, the bearing kurtosis value began to drop rapidly and approached the normal value, while vibration and noise began to increase significantly, and the increase rate began to accelerate. When the vibration exceeded the vibration specification, the bearing kurtosis value also began to increase rapidly. When the vibration specification is exceeded and the kurtosis value also exceeds the normal value (available kurtosis relative to the standard), it is considered that the bearing has entered late stage failure production, and the equipment needs to be repaired in time and NTN imported bearings are replaced.
The larger the equipment capacity, the time for the bearing to show the characteristics of late failure to the occurrence of serious failure (usually bearing damage such as shaft holding, burns, spalling of the sand frame, raceway, bead wear, etc.) will not exceed one week. The faster the speed, the shorter the interval time. Therefore, in the actual fault diagnosis of NTN imported bearings, once the late fault characteristics are found, the bearing should be determined decisively and repaired as soon as possible.
문서 첨부 제한 : 0Byte/ 5.00MB
파일 크기 제한 : 5.00MB (허용 확장자 : *.*)